CAUTION / NOTICE / HINT
NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.
HINT:
If the operation of a cellular phone or the navigation receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
PROCEDURE
1. |
CHECK USAGE CONDITION |
(a) Check that the vehicle and cellular phone meet the following conditions:
HINT:
If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the permission of the customer before performing it.
(b) Register the cellular phone again and check if it is registered correctly.
HINT:
If operation of the cellular phone or navigation receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
OK:
The cellular phone is registered correctly.
OK |
END (USAGE CONDITION IS DEFECTIVE) |
|
2. |
RESTART CELLULAR PHONE |
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ACC.
(c) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or navigation receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
OK:
The cellular phone is registered correctly.
OK |
END (TEMPORARY MALFUNCTION WITH "Bluetooth" OF CELLULAR PHONE) |
|
3. |
CHECK BRING CELLULAR PHONE NEAR IN-VEHICLE DEVICE |
(a) Place the cellular phone close to the navigation receiver assembly.
(b) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or navigation receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
OK:
The cellular phone is registered correctly.
OK |
END (TEMPORARY MALFUNCTION WITH "Bluetooth") |
|
4. |
CLEAR REGISTERED DEVICE INFORMATION |
(a) Clear all "Bluetooth" devices registered to the cellular phone and navigation receiver assembly.
(b) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If operation of the cellular phone or navigation receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
OK:
The cellular phone is registered correctly.
OK |
END (TEMPORARY MALFUNCTION WITH "Bluetooth") |
|
5. |
CHECK USING ANOTHER VEHICLE |
(a) Check if the cellular phone can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
HINT:
OK:
The cellular phone is registered correctly.
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
|
6. |
CHECK USING ANOTHER CELLULAR PHONE |
(a) Using another "Bluetooth" compatible cellular phone, register the cellular phone and check that it is registered correctly.
HINT:
OK:
The cellular phone is registered correctly.
OK |
END (ONLY A "Bluetooth" COMPATIBLE CELLULAR PHONE CAN BE USED) |
NG |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)
DESCRIPTION
The skid control ECU receives signals from the yaw rate and acceleration sensor
via the CAN communication system.
The yaw rate sensor has a built-in acceleration sensor and detects the vehicle's
condition using 2 circuits (GL1, GL2). If t ...
No Answer-Back
DESCRIPTION
In some cases, the wireless door lock control functions are normal but the hazard
warning light and/or wireless door lock buzzer answer-back function(s) does not
operate. In such cases, hazard warning light and wireless door lock buzzer signal ...