Toyota 4Runner: Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE PEDAL PAD
(a) Remove the brake pedal pad from the brake pedal sub-assembly.
2. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
(a) Remove the stop light switch mounting adjuster from the brake pedal support.
Components
COMPONENTS
ILLUSTRATION
...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS sys ...
Other materials about Toyota 4Runner:
Steering Angle Sensor Circuit (C15F1)
DESCRIPTION
The power steering ECU assembly receives steering angle signals from the steering
angle sensor via CAN communication. The power steering ECU assembly provides appropriate
assisting force in accordance with the steering angle signal.
...
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. CHECK REAR AIRBAG SENSOR LH (VEHICLE NOT INVOLVED IN COLLISION)
(a) Perform ...
0.0262