CUSTOMIZE PARAMETERS
1. CUSTOMIZING FUNCTION WITH TECHSTREAM
HINT:
The following items can be customized.
NOTICE:
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Customize Setting.
(e) Select the setting by referring to the table below.
Illuminated Entry
Display |
Default |
Content |
Setting |
---|---|---|---|
Lighting Time |
15s |
Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON). |
7.5s, 15s or 30s |
I/L when ACC OFF |
ON |
A function that turns on the lights when the ignition switch is turned from ON or ACC to off (the room light turns on when the interior light switch is set to DOOR). |
ON or OFF |
I/L ON W/Door Key Unlock*2 |
ON |
A function that turns on the room light when the door is unlocked with the door key cylinder (the room light turns on when the map light switch is set to DOOR). |
ON or OFF |
Room Light when Aprchd*1 |
ON |
A function that turns on the room light when the key is brought within the vehicle exterior detection area (the room light turns on when the map light switch is set to DOOR). |
ON or OFF |
Inside Foot Light*3 |
ON |
Changes the interior foot lights control. |
ON or OFF |
Mirr-Foot-Lgt Approached*4 |
ON |
Door mirror foot light (when approaching vehicle) |
ON or OFF |
Mirr-Foot-Lgt Unlocked*4 |
ON |
Door mirror foot light (when unlocking doors) |
ON or OFF |
Mirror Foot Light Time*4 |
15s |
Door mirror foot light illumination duration |
0s, 7.5s, 15s or 30s |
Light Control*5 |
ON |
Changes the inside handle illumination control. |
ON or OFF |
Interior Light Control |
ON |
Changes the engine switch illumination*1 or ignition key cylinder light*2 control. |
ON or OFF |
Exterior Light Control*4 |
ON |
Changes the door mirror foot light control. |
ON or OFF |
Motor LH Current Senser (62,63)
DESCRIPTION
When the side auto step motor current detection sensor inside the side auto step
controller ECU assembly detects a current of less than 1 A when the automatic running
board is operating, the side auto step controller ECU assembly does not oper ...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL OUTER MIRROR LIGHT ASSEMBLY BULB (w/ Side Turn Signal Light)
(a) Install t ...