INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
(a) Install the pintle hook support tube sub-assembly with the 6 bolts.
Torque:
81 N·m {826 kgf·cm, 60 ft·lbf}
2. INSTALL REAR BUMPER UPPER RETAINER LH
(a) Attach the 2 clips to install the rear bumper upper retainer LH.
3. INSTALL REAR BUMPER UPPER RETAINER RH
HINT:
Use the same procedure as for the LH side.
4. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH
5. INSTALL REAR COMBINATION LIGHT LENS AND BODY RH
HINT:
Use the same procedure as for the LH side.
6. INSTALL REAR BUMPER SIDE SUPPORT LH
(a) Attach the 5 claws to install the rear bumper side support LH.
(b) Install the 3 screws.
7. INSTALL REAR BUMPER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
8. INSTALL REAR BUMPER BAR REINFORCEMENT LH
(a) Install the rear bumper bar reinforcement LH with the 3 bolts.
9. INSTALL REAR BUMPER BAR REINFORCEMENT RH
HINT:
Use the same procedure as for the LH side.
10. INSTALL REAR BUMPER ENERGY ABSORBER
(a) Install the rear bumper energy absorber.
11. INSTALL REAR BUMPER COVER
(a) Attach the 18 claws to install the rear bumper cover.
(b) Install the 8 bolts and 4 screws.
12. INSTALL REAR QUARTER PANEL MUDGUARD LH
13. INSTALL REAR QUARTER PANEL MUDGUARD RH
HINT:
Use the same procedure as for the LH side.
14. INSTALL JACK BOX HOLE COVER
(a) Attach the 2 guides and 2 claws to install the jack box hole cover.
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK CERTIFICATION ECU
(a) Disconnect the F79 certification ECU connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wiring Color
Ter ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE
1. REMOVE FRONT WHEEL
2. REMOVE DISC BRAKE CYLINDER ASSEMBLY LH
3. REMOVE FRONT DISC
...