DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
U0073 |
CAN reception error |
CAN communication system |
U0140 |
CAN reception error |
CAN communication system |
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check if the same DTCs are output again.
OK:
No DTCs are output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
GO TO CAN COMMUNICATION SYSTEM |
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
NOTICE:
In the table below, the valves listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the T ...
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems ne ...