Registering a portable player in the Bluetooth® audio system allows the system to function. The following functions can be used for registered portable players:
Functions and operation procedures
Press and hold until “BT AUDIO”
is displayed.
Press (SETUP).
Select one of the following
functions using a voice command or .
• Registering a portable player “Pair Audio Players (Pair audio player)” • Selecting a portable player to be used “Select Audio Player” • Changing the registered name of a portable player “Change Name” • Listing the registered portable players “List Audio Players” • Changing the passkey “Set Passkey” • Deleting a registered portable player “Delete Audio Player”
Registering a portable player
Select “Pair Audio Players (Pair audio player)” using a voice command or
, and perform the procedure for
registering a portable player.
Selecting a portable player to be used
Select “Select Audio Player”
using a voice command or .
Select the portable player to be
used by either of the following methods, and select “Confirm” using a voice
command or :
a. Press the talk switch and say the name of the desired portable player.
b. Press the talk switch and say “List audio players”. When the name of the desired portable player is read aloud, press the talk switch.
Press the talk switch and say
“From car” or “From audio”, and select “Confirm” using a voice command or
.
Vehicles with smart key system: If “From car” is selected, the portable player will be automatically connected whenever the “ENGINE START STOP” switch is in either ACCESSORY or IGNITION ON mode.
Vehicles without smart key system: If “From car” is selected, the portable player will be automatically connected whenever the engine switch is in either the “ACC” or “ON” position.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" ...
Accessory Meter
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS system.
N ...