Toyota 4Runner: Slip Indicator Light does not Come ON
DESCRIPTION
Refer to Slip Indicator Light Remains ON (See page
.gif)
).
WIRING DIAGRAM
Refer to Slip Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the master cylinder solenoid, perform calibration (See page
).
PROCEDURE
|
1. |
READ VALUE USING TECHSTREAM (SLIP INDICATOR LIGHT) |
| A | .gif) |
REPLACE MASTER CYLINDER SOLENOID |
| B | |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
VSC OFF Indicator Light Remains ON
DESCRIPTION
Operation of the VSC OFF switch changes the vehicle between normal mode, TRAC
OFF mode*1 (AUTO LSD mode*2) and VSC OFF mode. During normal mode, pressing the
VSC OFF switch for a shor ...
Slip Indicator Light Remains ON
DESCRIPTION
The slip indicator light blinks during VSC, TRAC, crawl control, multi-terrain
select control or trailer sway control operation. When the system fails, the slip
indicator light comes ...
Other materials about Toyota 4Runner:
Steering Angle Sensor Internal Circuit (C1433)
DESCRIPTION
Steering angle sensor signals are sent to the skid control ECU via the CAN communication
system. When there is a malfunction in the CAN communication system, it is detected
by the steering angle sensor zero point malfunction diagnostic functio ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a DTC is output during the DTC check, check the parts listed in the
table below and proceed to the "See page" given.
*1: "Comes on" means the Malfunction Indicator Lamp (MIL) illumina ...
0.0083