Toyota 4Runner manuals

Toyota 4Runner: Using the hands-free phone system for the first time

Before using the hands-free phone system, it is necessary to register a cellular phone in the system. The phone registration mode will be entered automatically when starting the system with no cellular phone registered. Follow the procedure below to register a cellular phone:

Press the off-hook switch or the
talk switch.

The introductory guidance and phone name registration instructions are heard.

Select “Pair Phone” using a voice
command or .


Register a phone name by either
of the following methods.

a. Select “Record Name” using ,
and say a name to be registered.

b. Press the talk switch and say a name to be registered.

A voice guidance instruction to confirm the input is heard.

Select “Confirm” using a voice
command or .


Registration to the hands-free phone system only

Select “Phone Only” using a
voice command or .


Registration to the hands-free phone system and Bluetooth® audio system at the same time

Select “Int. Audio (Internal
audio)” using a voice command or .


Select “Confirm” using a voice
command or .


A passkey is displayed and heard, and a voice guidance instruction for inputting the passkey into the cellular phone is heard.

Input the passkey into the
cellular phone.

Refer to the manual that comes with the cellular phone for the operation of the phone.

Guidance for registration completion is heard.

Operating the system using a voice command
By following voice guidance instructions output from the speaker, voice commands enable the operation of the hands-free phone system without the need to check the display or operate . Operation p ...

Menu list of the hands-free phone system
Normal operation Using a short cut key Automatic volume adjustment When vehicle speed reaches 50 mph (80 km/h) or more, the volume automatically increases. The volume returns to the previo ...

Other materials about Toyota 4Runner:

Operating an iPod
Connecting an iPod enables you to enjoy music from the vehicle speakers. Connecting an iPod Pull up the lid. Open the cover and connect an iPod using an iPod cable. Turn on the power of the iPod if it is not turned on. Press . Control panel ...

Runnable Signal Malfunction (B2286,P0335)
DESCRIPTION The power management control ECU and ECM are connected by a cable and the CAN communication lines. These DTCs are stored when the crankshaft position sensor signal information from the cable and the crankshaft position sensor signal informatio ...

© 2016-2025 | www.to4runner.net

0.0094